6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
6-114 2450-901-01 Rev. B/September 2013
:TRACe:MAKE
This command creates a user-defined reading buffer.
Type Affected by Where saved Default value
Command only
Recall settings
Instrument reset
Saved setup Not applicable
Usage
:TRACe:MAKE <bufferName>, <bufferSize>
A user-supplied string that indicates the name of a user-defined buffer
A number that indicates the maximum number of readings that can be stored in
; minimum is 10
Details
This command creates a user-defined reading buffer.
You cannot assign user-defined reading buffers the same name as an existing buffer, including defbuffer1 or
defbuffer2.
Example
TRACe:MAKE "capTrace", 200
This example creates a 200-element reading buffer
named
.
Also see
Reading buffers (on page 3-10)
Remote buffer operation (on page 3-27)
:TRACe:MAKE (on page 6-114)
To Next Page
Loading...
