Keithley 2450 User Manual

Model 2450
Interactive SourceMeter® Instrument Reference Manual Section 6:
SCPI command reference
2450-901-01 Rev. B/September 2013 6-65
:SOURce[1]:CONFiguration:LIST:STORe
This command stores the active source settings into the named configuration list.
Type Affected by Where saved Default value
Command only
Recall settings
Instrument reset
Power cycle
Saved settings Not applicable
Usage
:SOURce[1]:CONFiguration:LIST:STORe <name>, <point>
<name>
A string that represents the name of a source configuration list
<point>
A specific configuration point in the configuration list
Details
Use this command to store the active settings to a configuration point in a configuration list. If you do not include
the <point> parameter, the configuration point will append to the end of the list.
Refer to Instrument settings stored in a source configuration list (on page 3-38) for information about the settings
this command stores.
Example
:SOURce:CONF:LIST:CRE "biasLevel"
:SOURce:FUNC VOLT
:SOURce:VOLT:LEV 5
:SOURce:CONF:LIST:STORE "biasLevel"
Create a configuration list named biasLevel.
Set the source function to voltage and the source
voltage level to 5 volts.
Store the configuration list and append it to the
end of the
biasLevel
configuration list.
Also see
:SOURce[1]:CONFiguration:LIST:CREate (on page 6-61)

Keithley 2450 Specifications

General

Model	2450
Category	SourceMeter
Voltage Source Range	±200 V
Current Source Range	±1 A
DC Voltage	200 V
DC Current	1 A
Power Output	20 W
Resolution	6.5 digits
Display	5-inch capacitive touchscreen
Operating Temperature	0°C to 50°C
Connectivity	USB, LAN, GPIB
Dimensions	213 mm × 88 mm × 370 mm