To Next Page

To Previous Page

Section

6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument

Reference Manual

6-116 2450-901-01 Rev. B/September 2013

:TRACe:SAVE

This command saves data from the specified reading buffer to a USB flash drive.

Type Affected by Where saved Default value

Command only

Not applicable

Usage

:TRACe:SAVE <fileName>, <bufferName>

:TRACe:SAVE <fileName>, <bufferName>, <timeFormat>

:TRACe:SAVE <fileName>, <bufferName>, <timeFormat>, <start>, <end>

A string that indicates the name of the file on the USB flash drive in which to save

the reading buffer

A string that indicates the reading buffer; the default buffers (defbuffer1 or

defbuffer2) or the name of a user-defined buffer; if no buffer is specified, this

parameter defaults to defbuffer1

Defines how date and time information from the buffer is saved in the file on the

USB flash drive; the values are:

• Dates, times, and fractional seconds are saved; the default value: FORMat

• Relative time stamps are saved: RELative

• Seconds and fractional seconds are saved: RAW

• Time stamps are saved:

STAMp

<start>

Defines the starting point in the buffer to start saving data

<end>

Defines the ending point in the buffer to stop saving data

Keithley 2450 User Manual

Other manuals for Keithley 2450