Keithley 2450

Model 2450
Interactive SourceMeter® Instrument Reference Manual Section 6:
SCPI command reference
2450-901-01 Rev. B/September 2013 6-167
Details
This command sets the timer event detector to the undetected state and resets the overrun indicator.
Example
:TRIG:TIM1:CLEar
Clears trigger timer 1.
Also see
:TRIGger:TIMer<n>:COUNt (on page 6-167)
:TRIGger:TIMer<n>:STARt:OVERrun? (on page 6-170)
:TRIGger:TIMer<n>:COUNt
This command sets the number of events to generate each time the timer detects its trigger event or is enabled as
a timer or alarm.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Save settings
1
Usage
TRIGger:TIMer<n>:COUNt <count>
TRIGger:TIMer<n>:COUNt?
<n>
A trigger timer number (1 to 4)
<count>
The number of times to repeat the trigger
Details
If count is set to a number greater than 1, the timer automatically starts the next delay at the expiration of the
previous delay.
Set count to zero (0) to cause the timer to generate trigger events indefinitely.
This command should not be used with the trigger model.
Example
TRIG:TIM2:COUN 4
Set the number of events to generate for
trigger timer 2 to four.
Also see
None