6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
6-96 2450-901-01 Rev. B/September 2013
:SYSTem:BEEPer[:IMMediate]
This command generates an audible tone.
Type Affected by Where saved Default value
Command only Not applicable Not applicable Not applicable
Usage
:SYSTem:BEEPer[:IMMediate] <frequency>, <time>
The frequency of the beep (20 to 8000)
The amount of time to play the tone in seconds (0.001 to 100)
Details
You can use the beeper of the Model 2450 to provide an audible signal at a specific frequency and time duration.
For example, you can use the beeper to signal the end of a lengthy sweep.
Example
Beep at 500 Hz for one second
Also see
None
:SYSTem:CLEar
This command clears the event log.
Type Affected by Where saved Default value
Command only Not applicable Not applicable Not applicable
Query
:SYSTem:CLEar
Details
This function removes all messages from the event log.
Also see
:SYSTem:ERRor[:NEXT]? (on page 6-98)
To Next Page
Loading...
