Keithley 2450 User Manual

Section
8: TSP command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
8-252 2450-901-01 Rev. B/September 2013
Example
value = userstring.get("assetnumber")
print(value)
Read the value associated with a user-defined
string named "assetnumber".
Store it in a variable called value, then print the
variable value.
Output:
236
Also see
userstring.add() (on page 8-249)
userstring.catalog() (on page 8-250)
userstring.delete() (on page 8-251)
waitcomplete()
This function waits for all overlapped commands in a specified group to complete.
Type TSP-Link accessible
Affected by Where saved Default value
Function
No
Usage
waitcomplete()
waitcomplete(group)
group
Specifies which TSP-Link group on which to wait
Details
This function will wait for all previously started overlapped commands to complete.
A group number may only be specified when this node is the master node.
If no group is specified, the local group is used.
If zero (0) is specified for the group, this function waits for all nodes in the system.
Any nodes that are not assigned to a group (group number is 0) are part of the master node's group.
Example 1
waitcomplete()
Waits for all nodes in the local group.
Example 2
waitcomplete(G)
Waits for all nodes in group G.
Example 3
waitcomplete(0)
Waits for all nodes on the TSP-Link network.
Also see
None

Keithley 2450 Specifications

General

Brand	Keithley
Model	2450
Category	Test Equipment
Language	English