Keysight Technologies C Series - Page 664

662 Keysight N9915-90020 User’s Guide
Channel Scanner (Option 312)
How to Set Up Channel Scanner
5. Optional: Auto Save ON (OFF = default)—When Auto Save is on, during
recording, the FieldFox stores intermediate results in a temporary file. If
the power fails during recording you can retrieve the results. Select
Recall
Log File. Select the temporary file name.
Press
Record Save/Recall > Auto Save On Off >On
Optional Step: Indoor Map Data Logging
Once you have selected a channel to measure, you can record data logging
using Indoor Mapping. Refer to
“Step 1A: Scan Mode: Range Channel
Defined” on page 651.
Learn more, see “How to Set Up Channel Scanner” on page 647, step 4.
1. Press Measure 1 > Data Logging > More then
2. Press
Indoor Map Data Logging then
— Record Indoor Data (new indoor mapping file (*.png)) or Recall
Indoor Log File (recall a previously stored *.kdat, to modify). Learn
more, refer to
Chapter 16 Mapping and “Option 352 Indoor Maps
Setup Procedure” on page 491
and “Setting up Data Logging” on
page 503
.
3. Measurements are displayed on the current indoor map in the specified
intervals.
— Use
More > Data Selection softkey menu to select the Channel
displayed, the
Sort Power Freq, and the Sort Order Up Down.
Then
Back.
— Use the
Labels & Icons softkey menu to select Labels OFF ON, Icons
Flag Point Line, and Pointer OFF ON.
Then
Back.
Learn more, refer to
Chapter 16 Mapping and to “Enabling and
Setting Up Indoor Map Logging” on page 506
.
Use the
Labels & Icons, RPG [Zoom] settings, Save Map, and Save
Image (PNG).
Learn more, refer to
Chapter 16 Mapping and to “Enabling and
Setting Up Indoor Map Logging” on page 506
.
— Use the
PAN softkey menu to change locations on the indoor map.
4. To begin recording (add a data point): Press
Record Data.
5. Optional: Set
Bearing Line, refer to “Enabling and Setting Up Indoor Map
Logging” on page 506
.
6. Repeat steps
4 and 5 as necessary.