Copying Using Memory (continued)
3-34
4. Position original(s).
Using platen glass:
Place original FACE DOWN. Start scanning from the first page.
Please Be Reminded!
When Dual Page, Non-Image Area Erase, Auto detection mode of
Repeat, or AUTO Layout is selected, keep the RADF open throughout
the scanning procedure.
Using RADF:
Position originals FACE UP.
If the number of originals exceeds 100, divide them into blocks not exceeding
100 sheets and load them from the block with the first page.
HINT
See p. 3-2 to p. 3-5 for details on positioning originals.
5. Press [START] to scan.
FOR DETAILS
Repeat steps 4 and 5 until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to
check the remaining memory.
To delete the scanned data without printing, press [STOP], then touch
EXIT on the confirmation screen to be sure the data is deleted.
HINT
Should memory overflow occur frequently, it is recommended that you
contact your Konica service representative to extend the memory
capacity in your machine.
6. Touch STORE to exit the Store mode.
STORE will return to the normal display.
7. Press [START].
All the data in memory will be output.
Press [STOP] to suspend the printing job.
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page
Loading...
