7-24
Using Finisher Manually
This function is available only with the Cover Sheet Feeder option (PI-110)
installed on the FS-110/210 Finisher. To use this convenient function, simply
place a set of paper into the lower tray of the cover sheet feeder, select the
desired mode from the Manual Finishing operation panel located on the top
of the Finisher, then press the Start/Stop button.
Available finishing modes according to the optional configuration are
described below.
FS-110 Finisher + PI-110 Cover Sheet Feeder
• 1 oblique staple
• 2 parallel staples
FS-110 Finisher + PI-110 Cover Sheet Feeder + PK-110/120/120 Type-A
Punching Kit
• 1 oblique staple
• 2 parallel staples
•Punch
FS-210 Finisher + PI-110 Cover Sheet Feeder
• 1 oblique staple
• 2 parallel staples
• Stitch & Fold (2 staples in the centre + Fold)
• Three-Fold
FS-210 Finisher + PI-110 Cover Sheet Feeder + PK-110/120/120 Type-A
Punching Kit
• 1 oblique staple
• 2 parallel staples
• Stitch & Fold (2 staples in the centre + Fold)
• Three-Fold
•Punch
>>>Specifications for Manual Staple 1 oblique staple and 2 parallel staples<<<
❒ Paper size: A3, B4, A4, A4R, B5, B5R, A5*, 11"x17", 8.5"x14", 8.5"x11",
8.5"x11"R
*A5 paper is available in portrait type feeding only.
❒ Paper weight: 50 ~ 200 g/m
2
❒ Staple capacity: 50 sheets max.
❒ Output tray: Primary (main) tray
>>>Specifications for Manual Punch<<<
❒ Paper size: A3 to B5
❒ Paper weight: 50 ~ 170* g/m
2
*: Some 170 g/m
2
paper types may not be punched easily.
❒ Punch capacity: 200 sheets max. (200 g/m
2
paper) or within 30 mm thick
❒ Output tray: Primary (main) tray
❒ The machine with PZ-108/109 Punching / Z-Folding unit requires PK-110/
120/120 Type-A Punching kit to use this function.
To Next Page
Loading...
