Eliminating Black Copy Marks Along Borders (Frame/Fold Erasure) (con-
tinued)
9-41
To specify Fold Erasure amount:
• Touch to highlight FOLD, if not highlighted, then use the touch screen key-
pad or up/down arrow key to enter the desired erasure amount, from 1 to 99
mm in 1 mm increments.
5. Touch OK.
The Application Selection Screen will be restored.
6. Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
7. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
8. Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
HINT
For details on positioning originals, see p. 3-2 to p. 3-5.
FOR DETAILS
When lowering the document feeder onto thick original (e.g. open book),
do not press it down too hard. Keep the document feeder open, if
required.
9. Press [START].
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Applications
Reverse
Image
Non-Image
Area Erase
Program Job
Dual Page
Image Insert
OHP
Interleave
Booklet
Combination
Chapter
Sheet/Cover
Insertion
Application
Selection Screen
Repeat
Frame/Fold
Erasure
AUTO
Layout
Full-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
To Next Page
Loading...
