Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
9-43
3. Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4. Select the desired magnification and paper size on the Basic
Screen.
FOR DETAILS
• APS and AMS are automatically released, and 1.00 (100%) is
selected as a magnification ratio.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode,
Platen store mode will function automatically.
5. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
6. Position original(s) FACE UP in the document feeder or FACE
DOWN on the platen glass.
HINT
For details on positioning originals, see p. 3-2 to p. 3-5.
Please Be Reminded!
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy
marks.
7. Press [START].
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Having Any Problem?
The AUTO layout function may not operate properly if the lighting in the
work place is directly over the platen glass. In this case, consult your
service representative about an appropriate place for installation.
Applications
Reverse
Image
Non-Image
Area Erase
Program Job
Dual Page
Image Insert
OHP
Interleave
Booklet
Combination
Chapter
Sheet/Cover
Insertion
Application
Selection Screen
Repeat
Frame/Fold
Erasure
AUTO
Layout
Full-Image
Area
Image Shift
Reduce &
Shift
Stamp
Overlay
Overlay
Memory
To Next Page
Loading...
