Konica Minolta 7255 - Section 3

3
Section 3:
Copying Operations
How to Make a Basic Copy
Positioning Originals .........................................................................3-2
Setting Print Quantity........................................................................3-6
Setting Job During Warm-up ............................................................3-7
To Stop Scanning/Printing ................................................................3-9
Selecting Paper Size ......................................................................3-10
Selecting Magnification Ratio (Lens Mode) ....................................3-14
Selecting Density Level ..................................................................3-18
Making Double-Sided Copy (1-2, 2-2) ............................................3-21
Making Single-Sided Copy from Double-Sided Originals (2-1).......3-27
Copying Using Special Paper (Multi-Sheet Bypass Tray) ..............3-29
Copying Using Memory ..................................................................3-33
Output Mode for Machine without Finisher .....................................3-41
Output Mode for Machine with Finisher ..........................................3-44
Output Mode for Machine with Shift Tray .......................................3-50
Selecting Binding Mode ..................................................................3-53
Recalling Previous Job Settings .....................................................3-54
Checking Feature Selections and Proof Copying ...........................3-55
Interrupt Copying ............................................................................3-59
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Mode
Binding
Mode
Shift Tray
Output Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode