Konica Minolta 7255 - Job Memory; Tray Auto Select Setting; Call Remote; Side 2 Lens

13-37
[11] Tray Auto Select Setting
Select to be detected or not to be detected, and priority of detection for each tray
when ATS/APS functions.
Key Operator Mode Screen 1 Key Operator Mode Screen 2
Tray Auto Select Setting Screen
Procedure
1 Touch [11] Tray auto select setting on the Key Operator Mode Screen to
display the Tray Auto Select Setting Screen.
2 On the left half of the screen, touch to highlight each tray key, then select OFF
or ON to specify whether the selected tray is to be automatically detected or not
when ATS/APS functions.
3 Tray keys specified as ATS/APS ON will appear on the right half of the screen.
Touch to highlight the desired tray key, then change its priority by using Up (c)
and Down (d) arrow keys.
4 Touch OK to complete the setting and restore the Key Operator Mode Screen.
5 If no further changes are required, touch RETURN to restore the Basic Screen
to perform copying operations.
Key Operator
Mode
Non-Image
Area Erase
Scan
Transmission
HDD
Management
Centring
Adjustment
Timing
Adjustment
Background
Adjustment
Finisher
Adjustment
Side 2 Lens
Adjustment
Call Remote
Centre
Machine
Management
List Print
Memory
Switch
Power Save
Setting
Tray Auto
Select Setting
Control Panel
Adjustment
Weekly
Timer
Key Operator
Data Setting
Panel Contrast/
Key Sound
Paper Type/
Special Size
Lock/Delete
Job Memory
E.K.C.
User Setting
Mode
Copier Initial
Setting
System Initial
Setting
Key Operator
Mode