Selecting Density Level (continued)
3-19
2. Select additional copy conditions, as desired.
HINT
See p. 13-12 to p. 13-13 to set the user-set density.
3. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
4. Position original(s).
HINT
See p. 3-2 to p. 3-5 for details on positioning originals.
5. Press [START].
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Mode
Binding
Mode
Shift Tray
Output Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
To Next Page
Loading...
