13-10
[2] Copier Initial Setting
Initial settings are the settings that display automatically when the copier is
powered on, when Auto Reset timer is operated, or when [AUTO RESET]
key is pressed. These settings can be changed by the Key Operator, as
shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition
to meet Energy Star requirements:
Initial Setting
Copy Mode : 1-1
Copy Density : AE
Lens Mode : 1:1
Paper Tray : APS
Output Mode : offset sort
When Initial settings are changed by the Key Operator, the new initial
settings display when the copier is powered on, when Auto/Reset timer is
reached, or when [AUTO RESET] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode : [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density : [AE; manual]
Lens mode : [AMS; ratio 0.25~4.00]
Paper tray : [APS; trays 1, 2, 3, 4, or LCT]
Output mode : [Non-sort; Sort, Group; Staple-sort; Stitch&Fold;
Fold; Punch; Z-fold; Three-fold; Cover sheet]
Special original : [Original Direction; Duplex Binding; Text/Photo
Enhance; Special Original; Original Form]
Rotation : OFF
Setting procedures are described on the following pages.
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the
overall and long-range effect of the change.
To Next Page
Loading...
