Turning On the Main Power Switch and Power Switch (continued)
2-23
Entering an EKC Password (EKC)
The Electronic Key Counter (EKC) allows the Key Operator to monitor all
copying activities by controlling EKC password accounts. Copy quantity
limits for specific accounts can be set.
The EKC is not factory-set. An EKC password is required only when the
EKC is activated; a User Password is assigned; and “Enter E.K.C.
password” is displayed on the touch screen.
Copying will be available by following procedure.
HINT
For details of the EKC setting, see p. 13-15 to p. 13-21.
1. Enter EKC password.
Enter your 8-digit EKC password, using the keypad.
HINT
For setting an EKC password, see p. 13-17 to p. 13-19.
FOR DETAILS
If an invalid EKC password is entered, continue by entering the correct
password.
2. Press [START].
Your current copy count and copy limit will be displayed for 3 sec.
Current count / limit
018888/025000
3. Start a copying job.
When the message changes to “Ready to copy”, copying job is available on
the machine.
FOR DETAILS
When your copy count reaches the copy limit, the message “Copy limit
reached” will be displayed. In that case, contact the Key Operator to
reset your copy limit.
4. Press [C] while pressing [P].
The initial state will be restored, with the message “Enter E.K.C. password”
displayed on the screen.
Machine
Information
Machine
Configuration
Turn On/Off
the Power
Loading
Paper
Changing
Paper Size
To Next Page
Loading...
