Using Two Copiers in Tandem (continued)
7-31
To Stop Scanning/Printing
To cancel the tandem copying job:
1. Press [STOP] on the control panel of the primary copier.
The scanning/printing job stops immediately, and the popup menu appears
on the Basic Screen of the primary copier to ask you whether to continue or
terminate the job. At this time, the tandem mode is not released.
2. Touch CONTINUE to go on, or EXIT to delete all the scanned data
and to release the tandem mode.
To cancel the job in the secondary copier only:
1. Press [STOP] on the control panel of the secondary copier.
The secondary copier stops the current operation immediately, and the
popup menu appears on the Basic Screen of the secondary copier to ask you
whether to continue or cease the operation. At this time, the tandem mode is
not released.
FOR DETAILS
If temporary suspension in the secondary copier takes a long time, the
Allocation recovery mode will activate, enabling the primary copier to
handle the remaining print quantity.
2.
Tou ch CONTINUE to go on, or EXIT to delete all the data transmitted
to the secondary copier and to release the tandem mode.
The primary copier will take over the remaining print quantity and complete
the job.
FOR DETAILS
Once the Allocation recovery mode is activated and the primary copier is
already handling the remaining print quantity, the secondary copier
cannot continue with the tandem printing job, even when CONTINUE is
touched on the popup menu.
To Next Page