Interrupt Copying (continued)
3-60
2. Set copy conditions, as desired.
The initial settings in Interrupt mode are as follows.
Copy Mode : 1-1
RADF : ON
AE : ON
Lens Mode : 1.00 (100%)
APS : ON
Print Quantity : 1
Finisher : Output to Secondary (Sub) tray
FOR DETAILS
Remove any document from the platen glass or from the document
feeder, if present.
3. Position original(s).
HINT
See p. 3-2 to p. 3-5 for details on positioning originals.
4. Press [START] to start the interrupt copying.
FOR DETAILS
When [CHECK] is pressed during Interrupt copying, the information
displayed reflects the initial copy job settings. Check mode will not
display Interrupt copy job information.
5. When Interrupt copying is completed, press [INTERRUPT] again.
The [INTERRUPT] LED turns out and the INTERRUPT indicator on the Basic
Screen returns to the JOB indicators.
The settings of the initial job will be restored on the Basic Screen.
6. Press [START] to resume copying.
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page