Copying Non-Standard Size Originals (Original Form) (continued)
8-13
3. Touch the desired size key.
FOR DETAILS
When selecting FULL AREA on the Non STD size mode menu, the
copier scans the whole area of the platen glass and copies with the
paper size or magnification ratio currently selected.
4. Touch OK on the popup menu to complete the setting.
The popup menu will disappear.
5. Touch OK to complete the setting and return to the Basic Screen.
6. Load copy paper.
HINTS
• To load tabbed copy paper in the Multi-sheet bypass tray, specify the
paper type as Tab paper. See p. 3-29 to p. 3-32.
To load tabbed copy paper in any other tray, specify the paper type
as Tab paper in the Key Operator mode. See p. 13-23 to p. 13-24.
• For the procedure of tabbed copy paper supply, see p. 2-31 to p. 2-
33.
7. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
8. Position original(s) FACE UP in the document feeder, or FACE
DOWN on the platen glass.
HINTS
• See p. 3-3 to p. 3-5 for details on positioning originals.
• Use RADF store mode (p. 3-33 to p. 3-34) when the original count
exceeds 100.
9. Press [START].
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Special
Original
Original
Form
Z-Folded
Original
Mixed
Original
Text/Photo
Enhance
Original
Binding Direction
Original
Direction
To Next Page
Loading...
