Programming Different Settings for an Output Job (Program Job)
(continued)
9-28
8. Repeat steps 4 to 7 until all JOB originals are scanned.
Please Be Reminded!
PLACE AND SCAN EACH ORIGINAL SET IN THE CORRECT ORDER
OF PAGINATION.
HINTS
• Memory overflow may occur during scanning. See p. 5-11 to p. 5-12.
• Should memory overflow occur frequently, it is recommended that
you contact your service representative to extend the memory
capacity in your machine.
9. Select the desired output mode and enter the print quantity from
the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
10. Touch STORE to exit the Store mode.
11. Press [START].
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page
Loading...
