Making Single-Sided Copy from Double-Sided Originals (2-1) (continued)
3-28
If double-sided originals are upside down on the reverse side and you want to
make single-sided copies of the same direction, touch TOP BIND.
Touch OK to return to the Basic Screen.
3. Select additional copy conditions, as desired.
FOR DETAILS
Some incompatible conditions may automatically release the selected
copy mode. In this case, arrange all the settings to be compatible with
the selected copy mode.
4. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
5. Position originals FACE UP in the document feeder according to
the original direction specified in step 2.
HINTS
• See p. 3-2 to p. 3-4 for details on positioning originals.
• Use RADF store mode (p. 3-33 to p. 3-34) when the original count
exceeds 100.
6. Press [START].
The machine starts to scan originals, then to print simplex copies when ready
for output.
Press [STOP] to suspend the scanning or printing job.
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page
Loading...
