Korg M3

An overview of Sequencer mode
193
Note: If you want to save the edited state of the combination,
use the Update Combination or Write Combination menu
commands.
3. Hold down the ENTER switch and press the REC/
WRITE switch.
The Setup to Record dialog box will appear.
4. To execute the Auto Song Setup function, press the OK
button. If you decide not to execute, press the Cancel
button.
You will automatically move to Sequencer mode, and the
settings of the combination will be copied to the song.
The first unused song will be the copy-destination song.
Contents automatically copied from a combination
The copied contents will be the same as when you execute
the menu command Copy From Combi with the following
settings in the dialog box. (see page 273)
• IFXs, MFXs, TFX checked
• Multi REC Standby checked
Contents automatically copied from a program
The copied contents will be the same as when you execute
the menu command Copy From Program with the following
settings in the dialog box. (see page 273)
• IFXs, MFXs, TFX checked
• KARMA checked
• To set to Track 01
• KARMA Module set to A
• with Drum Track checked
• To: Drum Track set to Track 10
• Check Multi REC Standby for tracks 01 and 10
5. The M3 will automatically enter record-ready mode,
and the metronome will sound according to the Metro-
nome setting (Seq 0–1–8b).
6. Press the START/STOP switch to begin realtime record-
ing. To stop recording, press the START/STOP switch
once again.