Sequencer mode
230
If you set KARMA Track Off Control to Off or On
settings and operate the KARMA ON/OFF switch
while real-time-recording a song, you must be aware of
the following points.
• In order to control this parameter during playback,
operations of the KARMA ON/OFF switch must be
recorded in real-time.
• Set KARMA On/Off (Global 2–2a) to MIDI CC#14. If
this is assigned to MIDI CC#14, operations of the
KARMA ON/OFF switch can be recorded in real-time.
For more information, please see “2–2a: KARMA
Controllers” on page 371.
• Operations will also be recorded if you assign this key to
MIDI CC#00–95, but in order to avoid confusion when
receiving another CC#, you should use CC#14.
• KARMA On/Off (Global 2–2a) will also be set to MIDI
CC#14 if you execute the menu command Reset
Controller MIDI Assign with To : set to Default Setting.
After executing, turn the assignment Off for other MIDI
CC# Assign –KARMA Controllers that you do not need
to record.
Use Program’s Scale [Off, On]
MIDI track can use the scale that is specified by Scale (Prog
1–2b).
On (checked): The scale specified by the program will be
used.
Off (unchecked): The scale specified by Scale will be used.
Track 02...08, 09...16 (Track Number):
These are the wave sequence and KARMA-related settings
for MIDI tracks 2–8 and 9–16. They are the same as for track
1. For more information, please see “Track 01 (Track
Number):,” above.
Scale:
This specifies the scale that the song will use. For more
information, please see “1–2b: Scale” on page 27.
Type (Song’s Scale)
[Equal Temperament...User Octave Scale15]
Selects the scale.
Key [C…B]
Random [0…7]
As this value is increased, an increasingly random deviation
will be added to the pitch at each note-on.
If Status (Seq 3–1(2)c) is INT, this setting will affect the
pitch produced by the M3. If Status is EXT, this setting
will affect the note number of the note messages
transmitted via MIDI.
▼3–7(8): Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Rename Song ☞p.271
• 4: Delete Song ☞p.271
• 5: Copy From Song ☞p.271
• 6: Load Template Song ☞p.271
• 7: Save Template Song (Save as User Template
Song) ☞p.272
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: GM Initialize ☞p.273
• 11: Copy From Combi (Copy from
Combination) ☞p.273
• 12: Copy from Program ☞p.273
For more information, please see “Sequencer: Menu
Command” on page 271.
To Next Page
Loading...
Need help?
General
