3-26 824 Reference Manual 9/29/09
Block - The timer will automatically turn the
instrument on and initiate a single measurement
beginning at a certain time on one day and ending
at a certain time on the same or another day.
NOTE: If the run time is later than the
stop time, then a measurement will start
on the stop date and end at the stop time
on the date AFTER the stop date.
1/Day - The timer will automatically turn the
instrument on and initiate one run/stop cycle per
day from the run date until the stop date.
2/Day - The timer will automatically turn the
instrument on and initiate two run/stop cycles per
day.
The three “enabled” modes (i.e. 1/Day, 2/Day, and Block)
use the dates set by the Run Date and Stop Date menu items
to determine the range of “valid” days on which to make
measurements.
Run Date - Specifies the starting date to take measurements.
Stop Date - Specifies the date to end the measurement and
disable the timer mode.
Run Time 1 / Stop Time 1 - These settings allow you to
specify the beginning and ending times of a measurement.
To Next Page
Loading...
