Lenze i950

0
+
t
v
v
max
TP
∆φ
-
P
-
1
1
x
(0x5021:151)
(0x5040:010), Bit 31
OR: Error code (0x603F:000) = 0x7304
(0x500B:011)
(0x5045:111)
(0x5045:112)
(0x5020:014)
(0x5045:011)
(0x2DA4:005)
(0x5020:009)
(0x5041:003)
(0x5042:003)
(0x5020:011)
(0x5042:001)
(0x5042:016)
(0x5041:008)
(0x5042:002)
(0x5041:005)
(0x5040:010
Bit 19)
(0x5042:006)
(0x5041:011)
(0x5042:005)
(0x5041:002)
(0x5042:017)
(0x5041:009)
(0x5041:010)
(0x5041:004)
(0x5041:012)
(0x5042:00/)
(0x5041:007)
(0x5041:006)
(0x5041:014)
(0x5042:004)
(0x5041:016)
(0x5041:017)
(0x5041:002)
Virtual Master
Mas
ter Value Source
Actual velocity
Systembus In Position
Source Master Values
Control Signals
Act Position Virtual Master
Act Velocity Virtual Master
Set Velocity Virtual Master
AI1: percent value scaled
Ref. Velocity Analog Input 1
DI 1
DI 2
DI 3
DI 4
Mark window
Master Value Correction
Actual mark error
Sensor Setposition
Mark distance master
Actual gearfactor
Co
rrected set
position
Activate Master value correction
Upper correction position
Mark Actposition
Max positive correction master
Selected Master
position
Gain gearfactor correction
Source TP 1
Max window marks
Correction Window reference
Lower correction position
Mark window size
Mark window offset
Max negative correction master
Corrected set
velocity
Selected Master
Velocity
Max gearfactor correction
Activate mark window master
Actual limited mark error
Enable gearfactor correction
Hold gearfactor correction
Mark distance
Correction window
Fig. 63: Master value
selecon und master value correcon
Conguring the "Sync and Correcon" TA
Signal ow
Master value selecon and master value correcon
148