Lenze i950 - Page 392

Starng recording
Press the buon , "Start recording"
In order to obtain a sample rate as high as possible when the parameter values are recorded,
the da
ta is rst saved in the measured data memory of the inverter and then transmied to
the Engineering PC as oscillogram. The current recording status is displayed in the status bar.
Adjusng the representaon
As soon as the diagram does not show the complete measurement anymore, a
scr
ollbar appears below the me axis. You can use the scrollbar to move the visi-
ble secon horizontally. The me-axis inscripon and the posion indicator are
automacally corrected during scrolling.
Aer recording and subsequent transmission of the online oscillogram to the Engineering PC,
it is visualised in the oscillosc
ope. If required, you can now adjust the representaon using the
zoom funcon or the automac scaling funcon.
Change me base subsequently
A measurement already carried out can be extended or compressed by changing the me
base.
For this purpose, change the seng of the me base via the toolbar (on top).
Addional
funcons
Oscilloscope funcon
392