Lenze i950 - Page 426

Acvaon of the
funcon
A data telegram is sent to the inverter via the safety bus. See chapter "Safe network interfa-
ces". ^ 441
Error behaviour
If the envelope curve is exceeded or when the absolute posion limits are exited, an error
message is triggered and an error stop with the funcon set in the 0x28DE:011 0x28DE:011
parameter is iniated.
Parameter
Address Name / seng range / [default seng] Info
0x28DC PDSS: Source SD-In
•
R
ead only
0 Deacvated
1 SD-In1
2 SD-In2
3 SD-In3
4 SD-In4
0x28DD PDSS: Source S bus
•
Read only
0 Deacvated
1 Acvated
0x28DE:001 PDSS parameters: PDSS: Permanent acvaon
•
R
ead only
0 On demand
1 Acvated
0x28DE:002 PDSS parameters: PDSS: Lower posion limit
•
R
ead only
0x28DE:003 PDSS parameters: PDSS: Upper posion limit
•
Read only
0x28DE:004 PDSS parameters: PDSS: Lower SCS limit
•
Read only
0x28DE:005 PDSS parameters: PDSS: Upper SCS limit
•
Read only
0x28DE:006 PDSS parameters: PDSS: SCS from lower limit
•
Read only: x rpm
0x28DE:007 PDSS parameters: PDSS: SCS from upper limit
•
R
ead only: x rpm
0x28DE:008 PDSS parameters: PDSS: Max. speed
•
Read only: x rpm
0x28DE:009 PDSS parameters: PDSS: Max. delay - lower limit
•
Read only
0x28DE:010 PDSS parameters: PDSS: Max. delay - upper limit
•
Read only
0x28DE:011 PDSS parameters: PDSS: Error response
•
Read only
0 STO
1 SS1
2 SS2
0x28DE:012 PDSS parameters: PDSS: Currently monitored speed
•
Read only: x rpm
0x28DE:013 PDSS parameters: PDSS: Min dierence monitored
speed
•
R
ead only: x rpm
0x28DF PDSS: PDSSpos monitored output
•
Read only
0 Deacvated
1 SD-Out1 posive logic
2 SD-Out1 negave logic
Safety
funcons
Posion-dependent Safe Speed (PDSS)
426