Lexmark T650 Series - Page 112

2-76 Service Manual
4062
Go Back
Previous
Next
28x.58
x = bin
number
Sensor (stapler pass
through) late jam
StapleSmart finisher
The media is late reaching the
sensor (stapler pass through)
within the specified time.
See “Sensor (output pass
through) late jam service
check” on page 2-141.
28x.59
x = bin
number
Staple ready home
position jam
Applies to:
StapleSmart finisher
The sensor (self priming) within
the stapler assembly does not
detect a ready staple in the
specified time after the staple
job was sent.
1. Check all the connections on
the controller card and the
stapler assembly.
2. Remove the staple cartridge
and remove all jammed
staples. If the cartridge is
jammed and can not be
removed, go to step 3.
3. Remove the stapler
assembly.
Go to “SFP stapler assembly
stapler unit assembly
removal” on page 4-183.
4. Manually rotate the drive
gears and reset the stapler.
Remove all jammed staples
then reinstall the stapler
assembly.
5. If problem remains, replace
the stapler assembly.
Go to “SFP stapler assembly
stapler unit assembly
removal” on page 4-183.
28x.60
x = bin
number
The status of stapler
motor is not defined
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.61
x = bin
number
DMID command is not
received for 500ms
after main motor runs
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.62
x = bin
number
When finishing job
isn't completed yet,
the first DMID
command of the next
job is received.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.63
x = bin
number
Bin clamp motor
control timer error.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Error
code or
message
Error contents Description/Action Possible repair actions