Lexmark T650 Series Service Manual

Diagnostic aids 3-57
4062-XXX
Go Back
Previous
Next
Wipe Disk
This setting provides you with a tool for erasing the contents of a disk.
Warning: Wipe Disk removes a disk's data in such a way that it cannot be recovered.
To change this setting:
1. Touch to select Wipe Disk from Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change
the setting. If no advanced password exists, you can establish one by using the keyboard that appears on
the LCD.
2. Touch to select Wipe disk (fast) or Wipe disk (secure).
Contents will be lost. Continue? appears on the touchscreen.
3. Touch Back to return to Configuration Menu.
4. Touch Yes to continue, or touch No to exit.
Font Sharpening
This setting allows a user to set a text point size below which the high frequency screens are used when
printing font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency
screens. The values for this setting range from 0 to 150, and the default value is 24. This setting affects
PostScript, PCL, and XL.
To change this setting:
1. Touch to select Font Sharpening from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
This function is not supported when the device generates output at 600 dpi resolution.
Require Standby
This setting determines if the Standby Mode is On or Off. The default is On.
If Standby Mode is On, the printer begins functioning in Standby Mode when it remains idle for an amount of
time. The Standby Mode enables the printer:
• To consume less energy than when operating in normal mode but not as little as when operating in Power
Saver
• To return to the Ready state more quickly than when operating in Power Saver
To change this setting:
1. Touch to select Require Standby from the Configuration Menu.
2. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.

Lexmark T650 Series Specifications

General

Print Technology	Monochrome Laser
Print Speed	Up to 45 ppm
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 200, 000 pages
Standard Output Capacity	250 sheets
Processor Speed	500 MHz
Connectivity	USB, Ethernet
Maximum Paper Size	8.5 x 14 inches
Operating System Compatibility	Windows, Mac OS, Linux
Memory	128 MB, expandable to 640 MB
Standard Input Capacity	650 sheets