4-128 Service Manual
4062-XXX
High capacity input tray (HCIT) media size actuator assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT controller card assembly. Go to “High capacity input tray (HCIT) controller card
assembly removal” on page 4-126.
2. Disconnect the two springs (A) from the frame.
Note: Leave the springs (A) attached to the cam size sensing plate (B) and the actuator switch (C).
3. Slide the cam size sensing plate (B) through the access hole in the rear side frame.
4. Snap loose the actuator switch (C) and remove.
To Next Page
Loading...
