3-26 Service Manual
4062-XXX
To view the maintenance page count:
1. Select Maint Cnt Value from CONFIG MENU.
2. Press to view the value.
Press Back to return to the main Configuration menu.
Maintenance page counter reset (Reset Cnt)
After scheduled maintenance, the servicer needs to reset the page counter.
To reset the maintenance page count to zero:
Select Reset Cnt from the Configuration menu, and then select Reset.
When the reset operation is complete, the display returns to the Configuration menu.
Print quality pages (Prt Quality Pgs)
The print quality test pages can be printed from either the Diagnostics mode or Configuration Menu (CONFIG
MENU). When printed from the Diagnostic mode, additional information is included, and the print cartridge
lockout is bypassed. See “Print quality pages (Prt Quality Pgs)” on page 3-7.
To print the Print Quality Test Pages, select Prt Quality Pgs from CONFIG MENU. The message Printing
Quality Test Pages is displayed.
The following is included in the CONFIG MENU version of the first print quality test page:
• Device information
• Printer revision levels
• Cartridge information
• Printer margin settings
• Minimum stroke width
The print quality test consist of four pages. Page one contains a mixture of graphics and text. Page two is gray
with two one inch black squares located on the bottom right. Page three is solid black page and page four is
blank. If duplex is turned on, the pages are duplexed. The Print Quality Test pages are printed in English and
must always be printed on letter, legal, or A4 paper.
Reports
Two different reports can be printed from this menu:
Menu Settings Page
Event log
To print the Menu Settings Page, select Reports from CONFIG MENU, and then Menu Settings Page. The
message Printing Menu Settings Page is displayed. The printed report contains:
• Reset Cnt
• Reports
• SIZE SENSING
• Factory Defaults
• Debug Information
To Next Page
Loading...
Need help?
General
