EasyManuals Logo

Lexmark T650 Series Service Manual

Lexmark T650 Series
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #226 background imageLoading...
Page #226 background image
3-18 Service Manual
4062-XXX
Go Back
Previous
Next
Sensor Tests (5-bin mailbox)
1. Select Sensor Tests from OUTPUT BIN TESTS.
2. Select Output Bin x (x=number of the output option to be tested).
The following screen is displayed:
Output Bin x
P1=OP P2=OP L=NL
• passThru—5-bin mailbox pass thru sensor shows Open or Closed
• mailboxEmpty—5-bin mailbox empty sensor shows Normal for a normal level, NearFull for nearly full,
and Full for full.
3. Manually actuate each of the sensors of the 5-bin mailbox,. The pass thru sensor will indicate Open or
Closed and the empty sensor (mailboxEmpty) indicates Normal, NearFull, or Full.
4. Press Back or Stop to exit the test.
Deflector Test
This test verifies the functioning of each of the 5-bin mailbox output media deflectors. If more than one 5-bin
mailbox is installed, all installed deflectors are tested.
To run the deflector Test, select deflector Test from the OUTPUT BIN TESTS. The test runs once and stops.
StapleSmart FINISHER TESTS
Staple Test
This test verifies the staple mechanism by sending eight sheets of media from the printers default paper source
and stapling the sheets.
To run the Staple Test:
1. Select Staple Test from FINISHER TESTS.
2. Select the output bin, and press
.
While the test runs the power indicator blinks and the message Staple Test Running… displays. During
the test, no buttons are active and the test cannot be canceled until the test is complete.
Feed Tests (finisher)
This test is used to verify whether or not media can be fed to a finisher output bin. Eight sheets of blank paper
are fed from the default paper source and fed to the finisher output bins.
Note: This test can be run using any of the paper sizes supported by the printer.
To run the Feed Test, select Feed Tests from FINISHER TESTS. While the feed test runs, the power indicator
blinks, and the message Feed Test Running… displays.
During the test, no buttons are active, and the test cannot be stopped until the test is completed.
Sensor Test (finisher)
This test can be used to verify whether or not the finisher sensors are working correctly.

Table of Contents

Other manuals for Lexmark T650 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark T650 Series and is the answer not in the manual?

Lexmark T650 Series Specifications

General IconGeneral
Print TechnologyMonochrome Laser
Print SpeedUp to 45 ppm
Print Resolution1200 x 1200 dpi
Monthly Duty CycleUp to 200, 000 pages
Standard Output Capacity250 sheets
Processor Speed500 MHz
ConnectivityUSB, Ethernet
Maximum Paper Size8.5 x 14 inches
Operating System CompatibilityWindows, Mac OS, Linux
Memory128 MB, expandable to 640 MB
Standard Input Capacity650 sheets

Related product manuals