Mitsubishi Electric MELSEC iQ-R Series - Page 1753

21 A/D CONVERSION INSTRUCTIONS
21.3 Restoring the User Range Setting Values
1751
21
• For R60DAV8, R60DAI8, R60DA8-G
*2 For the R60DAV8 and the R60DAI8, this area corresponds to System area and so is not available.
Operand: (s)
Device Item Description Setting range Set by
+0 System area 
+1 Completion status The instruction completion status is stored.
• 0: Completed successfully
• Other than 0: Completed with an error (error code)
 System
+2 Save data type setting
*2
Used to store the set value that was set for Save data type
setting (s)+2 in the G(P).OGLOAD instruction.
• 0H: User range setting 1 (current specification)
• 1H: User range setting 2 (voltage specification)
• 2H: User range setting 3 (voltage specification)
0000H to
AAAAH
System
+3 System area 
+4 CH1 Factory default setting offset value System
+5 CH1 Factory default setting gain value System
+6 CH2 Factory default setting offset value System
+7 CH2 Factory default setting gain value System
+8 CH3 Factory default setting offset value System
+9 CH3 Factory default setting gain value System
+10 CH4 Factory default setting offset value System
+11 CH4 Factory default setting gain value System
+12 CH5 Factory default setting offset value System
+13 CH5 Factory default setting gain value System
+14 CH6 Factory default setting offset value System
+15 CH6 Factory default setting gain value System
+16 CH7 Factory default setting offset value System
+17 CH7 Factory default setting gain value System
+18 CH8 Factory default setting offset value System
+19 CH8 Factory default setting gain value System
+20 CH1 User range setting offset value System
+21 CH1 User range setting gain value System
+22 CH2 User range setting offset value System
+23 CH2 User range setting gain value System
+24 CH3 User range setting offset value System
+25 CH3 User range setting gain value System
+26 CH4 User range setting offset value System
+27 CH4 User range setting gain value System
+28 CH5 User range setting offset value System
+29 CH5 User range setting gain value System
+30 CH6 User range setting offset value System
+31 CH6 User range setting gain value System
+32 CH7 User range setting offset value System
+33 CH7 User range setting gain value System
+34 CH8 User range setting offset value S
ystem
+35 CH8 User range setting gain value System
+36 System area 
b15 b3b4b5b6b7b8b9b10b11b12b13b14 b2 b1 b0
CH8 CH7 CH6 CH5 CH4 CH3 CH2
CH1