NEC Australia Pty Ltd Xen Master & Xen Axis
7 - 238 Installing Optional Equipment
A6-324000-642-01 – Release 4.0
May 2001
8. With the WMU-UA Unit attached to the wall, hook the
two bottom tabs on the WMU-UA Mount Unit into the
tab slots on the Multiline Terminal. Then push the two
top tabs on the WMU-UA Unit into the tab slots on the
Multiline Terminal. If the adaptor has a power supply,
lead the AC adaptor cord out through the opening at
the bottom of the Multiline Terminal. Refer to Figure
7-73 Attaching the Multiline Terminal to the WMU-UA
Unit.
3.10.4 Removing the Multiline Terminal from the Base Cover
To remove the Multiline Terminal from the base cover, lift
the Multiline Terminal to disengage top tabs, turn it slightly
counter clockwise to unlock lower tabs on base cover, and
remove it.
Figure 7-73 Attaching the Multiline Terminal to the WMU-UA Unit
Figure 7-74 Removing the Multiline Terminal from the Base Cover
Wall
WMU-UA
Unit
Tab Slots
Multiline
Terminal
adaptor
To Next Page
Loading...
Need help?
General
