NEC Xen Master - Chapter 3 Hardware Requirements; Table 3-6 Sample Axis Port Assignment; Table 3-7 Number of Required Interface Etus

NEC Australia Pty Ltd Xen Master & Xen Axis
3 - 42 Hardware Requirements
A6-324000-642-01 – Release 4.0 May 2001
Xen Axis:
7.2.2 Determining the Number of Required Interface ETUs
Table 3-7 Number of Required Interface ETUs indicates
each feature and the associated hardware necessary for
the operation of the feature.
Slot ETU
S1 ESI(8)-U13 (Built-in)
S2/ISA MIFM-U13
S3 COI(8)-U13
S4 TLI(2)-U13
S5 ESI(8)-U13
S6 SLI(8)-U13
S7 VMS(8)-U13
Table 3-6 Sample Axis Port Assignment
Telephone
Ports
1 ~ 8
MIF
01
Ports
1~8
Telephone
Ports
9~10
Telephone
Ports
9~16
Telephone
Ports
17~24
Telephone
Ports
25~32
S1 S2 S3 S4 S5 S6 S7
Table 3-7 Number of Required Interface ETUs
Feature
Required ETU or
Unit
Required
Feature Key
Maximum
ETUs per
System
Least Cost Routing MIFM-U13 KMM(XXX)UA
or
KML(XXX)UA
1
SMDR MIFM-U13 None 1
PC Programming MIFM-U13 None 1
Caller ID (Refer to Note) MIFM-U13 KMM(XXX)UA 1
Uniform Call Distribution MIFA-U13 None 1
Automatic Call Distribution
(Xen Master Only)
MIFA-U13 KMA(XXX)UA 1
Note: The Caller ID feature works without the MIFM-U13 ETU. However,
the Caller ID scrolling and dialling functions both require the MIFM-
U13 ETU.