Oce PlotWave 900 User Manual

4.
Use both hands to put the holder in the paper roll compartment. First, position the left-
hand side of the holder in its notch, then position the right-hand side in its notch.
[179] Put the roll into the paper roll compartment
5.
If the new roll does not have a straight leading strip you can cut it manually.
6.
Press the correct button inside the paper roll compartment and feed the paper between
the input guide plates as indicated by the arrow. The material is fed into the machine.
Note:
Also see the stickers inside the roll compartments on how to feed paper.
[180] Button to feed the media
7.
Close the paper roll compartment. The material is cut. The size of material is indicated
on the operator panel.
8.
Define the media type: See ‘Preferred Océ media types and sizes’ on page 374.
Chapter 11 - System maintenance266
Replace/Load a roll of media

Oce PlotWave 900 Specifications