R&S FSW Series - Page 1138

Remote Commands
R&S
®
FSW
1138User Manual 1173.9411.02 ─ 43
DISPlay[:WINDow<n>]:SGRam:COLor[:STYLe].............................................................. 1139
DISPlay[:WINDow<n>]:SPECtrogram:COLor[:STYLe]......................................................1139
DISPlay[:WINDow<n>]:SGRam:COLor:DEFault
DISPlay[:WINDow<n>]:SPECtrogram:COLor:DEFault
This command restores the original color map.
Suffix:
<n>
.
Window
Manual operation: See "Set to Default" on page 602
DISPlay[:WINDow<n>]:SGRam:COLor:LOWer
<Percentage>
DISPlay[:WINDow<n>]:SPECtrogram:COLor:LOWer <Percentage>
This command defines the starting point of the color map.
Suffix:
<n>
.
Window
Parameters:
<Percentage> Statistical frequency percentage.
Range: 0 to 66
*RST: 0
Default unit: %
Example:
DISP:WIND:SGR:COL:LOW 10
Sets the start of the color map to 10%.
Manual operation: See "Start / Stop" on page 601
DISPlay[:WINDow<n>]:SGRam:COLor:SHAPe <Shape>
DISPlay[:WINDow<n>]:SPECtrogram:COLor:SHAPe <Shape>
This command defines the shape and focus of the color curve for the spectrogram
result display.
Suffix:
<n>
.
Window
Parameters:
<Shape> Shape of the color curve.
Range: -1 to 1
*RST: 0
Manual operation: See "Shape" on page 602
DISPlay[:WINDow<n>]:SGRam:COLor:UPPer <Percentage>
DISPlay[:WINDow<n>]:SPECtrogram:COLor:UPPer <Percentage>
This command defines the end point of the color map.
Analyzing Measurements (Basics)