R&S FSW Series - Page 1223

Remote Commands
R&S
®
FSW
1223User Manual 1173.9411.02 ─ 43
ON | 1
Switches the function on
Example:
CALC:LIM:STAT ON
Switches on the limit check for limit line 1.
Manual operation: See "Disable All Lines" on page 566
CALCulate<n>:LIMit<li>:TRACe<t>:CHECk <State>
This command turns the limit check for a specific trace on and off.
To query the limit check result, use CALCulate<n>:LIMit<li>:FAIL?.
Note that this command replaces the two commands from previous signal and spec-
trum analyzers (which are still supported, however):
●
CALCulate<n>:LIMit<li>:TRACe<t> on page 1371
●
CALCulate<n>:LIMit<li>:STATe on page 1222
Suffix:
<n>
.
Window
<li> Limit line
<t> Trace
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:LIM3:TRAC2:CHEC ON
Switches on the limit check for limit line 3 on trace 2.
Manual operation: See "Traces to be Checked" on page 565
MMEMory:LOAD<n>:LIMit <FileName>
Loads the limit line from the selected file in .CSV format.
Suffix:
<n>
.
irrelevant
Parameters:
<FileName> String containing the path and name of the CSV import file.
Example:
MMEM:LOAD:LIM 'C:\TEST.CSV'
Manual operation: See "Import" on page 569
MMEMory:STORe<n>:LIMit <FileName>, <LimitLineName>
This command exports limit line data to an ASCII (CSV) file.
Analyzing Measurements (Basics)