R&S FSW Series - Page 569

Common Analysis and Display Functions
R&S
®
FSW
569User Manual 1173.9411.02 ─ 43
Remote command:
CALCulate<n>:LIMit<li>:CONTrol[:DATA] on page 1212
CALCulate<n>:LIMit<li>:LOWer[:DATA] on page 1215
CALCulate<n>:LIMit<li>:UPPer[:DATA] on page 1218
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see "X-Offset" on page 565).
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:SHIFt on page 1214
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see "Y-Offset" on page 566).
Remote command:
CALCulate<n>:LIMit<li>:LOWer:SHIFt on page 1216
CALCulate<n>:LIMit<li>:UPPer:SHIFt on page 1220
Save
Saves the currently edited limit line under the name defined in the "Name" field.
Import
Opens a file selection dialog box and loads the limit line from the selected file in .CSV
format.
Note that a valid import file must contain a minimum of required information for the
R&S FSW.
For details on the file format see Chapter 9.4.2.4, "Reference: Limit Line File Format",
on page 574.
Remote command:
MMEMory:LOAD<n>:LIMit on page 1223
File Explorer ← Import
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
Export
Opens a file selection dialog box and stores the currently displayed limit line to the
defined file in .CSV format.
Display and Limit Lines