R&S FSW Series - Page 863

Remote Commands
R&S
®
FSW
863User Manual 1173.9411.02 ─ 43
GSM
Transmission according to GSM standard
WCDMa
Transmission according to W-CDMA standard
LTE_1_40 | LTE_3_00 | LTE_5_00 | LTE_10_00 | LTE_15_00 |
LTE_20_00
Transmission according to LTE standard for different channel
bandwidths
NR5G_fr1_5_00 | NR5G_fr1_10_00 | NR5G_fr1_15_00 |
NR5G_fr1_20_00 | NR5G_fr1_25_00 | NR5G_fr1_30_00 |
NR5G_fr1_40_00 | NR5G_fr1_50_00 | NR5G_fr1_60_00 |
NR5G_fr1_70_00 | NR5G_fr1_80_00 | NR5G_fr1_90_00 |
NR5G_fr1_100_00 | NR5G_fr2_50_00 | NR5G_fr2_100_00 |
NR5G_fr2_200_00 | NR5G_fr2_400_00
Transmission according to new radio 5G standard
USER
User-defined transmission; no automatic preconfiguration possi-
ble
Manual operation:
See "Technology Used for Transmission" on page 185
[SENSe:]POWer:ACHannel:SBLock<sb>:TXCHannel:COUNt <Number>
This command defines the number of transmission channels the specific sub block
contains.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 842).
Suffix:
<sb>
.
1 to 8
sub block number
Parameters:
<Number> Range: 1 to 18
*RST: 1
Manual operation: See "Number of Tx Channels (Tx Count)" on page 184
[SENSe:]POWer:ACHannel:SPACing:UACHannel <Spacing>
This command defines the distance from the transmission channel to the upper adja-
cent channel.
For MSR signals, this command defines the distance from the CF of the last Tx chan-
nel in the last sub block to the upper adjacent channel in asymmetrical configurations.
To configure the spacing for the lower adjacent channel use the [SENSe:]POWer:
ACHannel:SPACing[:ACHannel] command.
Configuring and Performing Measurements