Remote Commands
R&S
®
FSW
862User Manual 1173.9411.02 ─ 43
Remote commands exclusive to MSR adjacent channel setup:
[SENSe:]POWer:ACHannel:SBLock<sb>:RFBWidth..........................................................862
[SENSe:]POWer:ACHannel:SBLock<sb>:TECHnology[:CHANnel<ch>]...............................862
[SENSe:]POWer:ACHannel:SBLock<sb>:TXCHannel:COUNt............................................ 863
[SENSe:]POWer:ACHannel:SPACing:UACHannel.............................................................863
[SENSe:]POWer:ACHannel:SPACing:UALTernate<ch>......................................................864
[SENSe:]POWer:ACHannel:SSETup................................................................................864
[SENSe:]POWer:ACHannel:BWIDth:UACHannel...............................................................864
[SENSe:]POWer:ACHannel:BANDwidth:UACHannel......................................................... 864
[SENSe:]POWer:ACHannel:BWIDth:UALTernate<ch>........................................................865
[SENSe:]POWer:ACHannel:BANDwidth:UALTernate<ch>.................................................. 865
[SENSe:]POWer:ACHannel:FILTer:ALPHa:UACHannel......................................................865
[SENSe:]POWer:ACHannel:FILTer:ALPHa:UALTernate<ch>...............................................865
[SENSe:]POWer:ACHannel:FILTer[:STATe]:UACHannel.....................................................866
[SENSe:]POWer:ACHannel:FILTer[:STATe]:UALTernate<ch>..............................................866
[SENSe:]POWer:ACHannel:SBLock<sb>:RFBWidth <Bandwidth>
This command defines the bandwidth of the individual MSR sub block. Note that sub
block ranges also affect the position of the adjacent gap channels (CACLR).
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 842).
Suffix:
<sb>
.
1 to 8
sub block number
Parameters:
<Bandwidth> Bandwidth in Hz
Default unit: Hz
Manual operation: See "RF Bandwidth" on page 184
[SENSe:]POWer:ACHannel:SBLock<sb>:TECHnology[:CHANnel<ch>]
<Standard>
This command defines the technology used for transmission by the specified MSR Tx
channel.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 842).
Suffix:
<sb>
.
1 to 8
sub block number
<ch> 1..n
Tx channel number
Parameters:
<Standard> Technology used for transmission
Configuring and Performing Measurements