2.Installation
110
3. Wait for the machine to finish formatting the hard disk.
• Do not touch the power switch while the hard disk format is in progress. Wait for the
machine to tell you that the formatting is finished.
4. Turn the main power OFF/ON after the "Hard Disk is formatted" message.
5. Enter the SP mode.
6. Execute SP5-853-001 to copy the preset stamp data from the firmware to the hard disk. Follow the
instructions on the screen. This will require three or four minutes.
7. Turn the main power OFF/ON.
Installation Procedure (IM 550F/600F)
• Turn OFF the main power, and unplug the machine power cord before starting the following
procedure.
1. Open the rear upper cover [A].
To Next Page
Loading...
