2.Installation
139
the harness guides, as shown below.
• When reattaching the bracket [A] of the controller box [B], do not interpose the harness
and the flat cable between the bracket and the controller box.
After Installing the HDD
1. Connect the power cord and turn ON the main power.
The message "Hard Disk is replaced. Format Hard Disk." is displayed.
2. Select [Format]. The message "Formatting Hard Disk…Please wait, also make sure the main
power switch is not turned off." is displayed.
3. Wait for the machine to finish formatting the hard disk.
• Do not touch the power switch while the hard disk format is in progress. Wait for the
machine to tell you that the formatting is finished. When the formatting is finished, the
message "Hard Disk is formatted. Turn the main power switch off then on" is displayed.
4. Turn the main power OFF/ON after the message tells you formatting is finished.
To Next Page
Loading...
