8.Smart Operation Panel G2.5
737
Speaker (OT1) Check
Tests the speaker (OT1) by playing the sound samples.
1. Select the frequency (220Hz, 440Hz, 880Hz, 1760Hz, or 2000Hz).
2. Press [START/STOP] to play the sound.
3. Touch the volume bar, and play the sound at minimum and maximum volumes.
4. Press [START/STOP] to stop the sound.
When the check is completed, press [Back] to return to the top menu of [Self Check].
TouchPanel Check
For each of the nine reference points on the screen, the distance between the detected pressed
position and the nearest reference point is displayed. The last detected distance remains displayed
near each reference point.
To complete the check, press the five reference points (four corners and the center).
If the distance between the detected pressed position and the reference point is within ±12 px for each
of the five points, the [OK] button appears.
(However, even when the [OK] button is being displayed, if you press the screen again and the distance
exceeds ±12px, the [OK] button disappears.)
To Next Page
Loading...
