8.Smart Operation Panel G2.5
722
press and hold the main power switch for 6 seconds. However, if you force a shutdown during the
shutdown process, data being processed may be lost. The forced shutdown is to be used to shut down
the MFP without disconnecting the power cord when the shutdown process cannot be completed.
Other Shutdown Functions
This MFP has two additional shutdown functions to facilitate maintenance.
Shutting down the MFP for parts replacement (Starting up in Normal mode when Quick mode is
selected)
When Quick mode is selected, the MFP prepares for the next startup when it shuts down. This causes
the shutdown process to take longer than when Normal mode is selected.
If you need to disconnect the power cord after shutdown in order to replace parts or for other reasons,
you can use the following procedure to shut down the MFP just like you do in Normal mode. This
shortens the time it takes to shut down the MFP.
• Procedure
Turn the main power switch OFF while holding down the [Stop] key on the control panel. Continue
to hold down the [Stop] key until the shutdown screen is displayed.
Shutting down the MFP for software updates (Shutting down the MFP with the control panel in
Sleep mode)
If you are going to turn ON the MFP within 5 minutes, you can use the following procedure to shut down
the MFP with the control panel in Sleep mode.
• Procedure
Turn the main power switch OFF while holding down the [EX1] key. Continue to hold down the
[EX1] key until the shutdown screen is displayed.
• You must turn ON the MFP within 5 minutes.
• If more than 5 minutes has elapsed after shutting down the MFP using the above procedure,
the machine starts up in Normal mode even if Quick mode is selected.
To Next Page
Loading...
