8.Smart Operation Panel G2.5
746
update from sdcard] and follow the instructions. See "Recovery Mode".
Installation/Update from the eDC Server
Downloads applications from the eDC Server, and installs or updates them.
• Installation/activation/update of applications from the server can only be done in the service
mode.
Check Server Connect
1. Log in to the control panel’s service mode.
2. Select [Apps] > [Install].
3. Press [Check Server Connect] and make sure that “Connect Server Succeeded!” is displayed.
• The server address is stored in the firmware of the Smart Operation Panel.
• To connect to the server, the network settings of the MFP must be configured correctly.
For the required configuration, see the Field Service Manual of the MFP.
• If the server connection fails, see Troubleshooting for error codes.
Installation
1. Log in to the control panel’s service mode.
2. Select [Apps] > [Install].
3. Select [Install from Server].
To Next Page
Loading...
