6.Troubleshooting
616
to change the paper type.
5. Change the paper type setting to thicker in [Paper Thickness].
• P 800/801
1. Press the [Menu] key on the control panel.
2. Select [Paper Input] -> Press [OK]
3. Select the tray from [Tray Paper Size: Tray 1] to [Tray Paper Size: Tray 5] for which you want
to change the paper type -> Press [OK]
4. Change the paper type setting to thicker -> Press [OK] The setting is complete when
specifying the following types of paper: Thin Paper, Plain Paper, Plain Paper 2, Middle Thick,
Thick Paper 1, Thick Paper 2, Thick Paper 3, Special Paper 1, Special Paper 2, Special Paper
3
5. If you have selected [Recycled Paper], [Color Paper], [Letterhead], [Label Paper], [Envelope],
or [Preprinted Paper] for the paper type, press [Escape].
6. Select [Maintenance] -> Press [OK]
7. Select [General Settings] -> Press [OK]
8. Select the paper thickness setting for the specified paper type -> Press [OK]
9. Select the tray where the specified type of paper is loaded -> Press [OK] If you selected
[Letterhead Setting], [Label Paper Setting], or [Envelope Setting] in Step 8, you can specify the
paper thickness for each tray separately. For other paper types, the specified paper thickness
is applied to all trays.
10. Change the paper type setting to thicker -> Press [OK].
Toner scattering
Symptom
The toner spreads under the horizontal lines.
Solution 1
Enable the scattered toner prevention function with SP1-891-xxx (Scattering Control).
Change the value of the tray which you want to adjust.
To Next Page
Loading...
