Ricoh IM 550F

5.System Maintenance
526
Test Pattern Printing
Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for
design testing.
• Do not operate the machine until the test pattern is printed out completely. Otherwise, SC will
occur.
IM 550F/600F/600SRF
1. Enter the SP mode and select SP2-109-003 (Pattern Selection).
2. Select the test pattern for print from the list then press [OK].
3. To change the density of the test pattern, select the density with SP2-109-006, then press [#].
• If select "0" with SP2-109-006, the color adjusted so will not show up in the test pattern.
4. To print, touch [Copy Window], then set settings within the following window for test print (paper
size, etc.).
5. Press [Start] to start test print.
6. After checking the test pattern, press [SP Mode] to return to SP mode display.
7. Reset all settings to the default values (SP2-109-003, SP2-109-006).
8. Exit SP mode.
No.
Pattern
No.
Pattern
0
None
12
Independent Pattern (2 dots)
1
Vertical Line (1 dot)
13
Independent Pattern (4dot)
2
Vertical Line (2 dots)
14
Trimming Area
3
Horizontal Line (1 dot)
15
Hound's Tooth Check (Horizontal)
4
Horizontal Line (2 dots)
16
Hound's Tooth Check (Vertical)
5
Grid Vertical Line
17
Black Band (Horizontal)
6
Grid Horizontal Line
18
Black Band (Vertical)
7
Grid Pattern Small
19
Checker Flag Pattern
8
Grid Pattern Large
20
Grayscale (Vertical)
9
Argyle Pattern Small
21
Grayscale (Horizontal)
10
Argyle Pattern Large
22
Two Beam Density Pattern
11
Independent Pattern (1 dot)
23
Full Dot Pattern
P 800/801
1. Enter the SP mode and select SP2-109-003 (Test Pattern).
2. Enter the number for the test pattern that you want to print -> Press [OK].
SP2-109-003 (Test Pattern)