Ricoh IM 550F

8.Smart Operation Panel G2.5
741
Special Key Combinations
Function
Operation for Smart Operation Panel
Resetting Settings
In the Settings screen, press a Settings category while holding down
the EX3 key.
Available for: System Settings, Copier/Document Server Settings,
and Scanner Settings.
System Reset
Hold down the EX3 key and [#] simultaneously for 10 seconds.
Resets the controller software of the main machine.
Application Reset
Hold down the EX3 key and [9] simultaneously for 10 seconds.
Resets a single application.
Resetting User Code
Authentication
Hold down [Reset] for 2 seconds.
Returns to the User Code entry screen.
Backup/Restore for Smart Operation Panel Application/Settings Function
Overview
Application settings and additional applications installed on the Smart Operation Panel can be backed
up automatically and can be restored, e.g. after Smart Operation Panel replacement.
In Cheetah SP mode, select [Screen Device Settings]> [Backup / Restore Settings].
Data that can be backed up and restored
• System application settings
*1
• Standard application settings
*1
• Pre-install application settings
*1
• Add-on applications (including hybrids)
*2
*1: The system application, standard installed application, and pre-installed application are installed in
MultiLink-Panel, so the application itself is not backed up or restored after replacement.
*2: Add-on applications settings are not backed up or restored.
Backup
• Backup cannot be performed manually by the user or the technician.
• During the backup, the message being backed up is displayed and other operations cannot be
performed.
• A backup is performed 24 hours after the last backup. If the machine doesn’t have backup data, the
first backup is performed at 2:00 AM.
• A backup cannot be performed under any of the conditions below and will retry 1 hour later.
• During ARFU, firmware updating from the download site, etc