8.Smart Operation Panel G2.5
753
Error Messages
Insert a correct SD card.
• Remove the SD card and insert it
again.
• Make sure that the directory of the
SD card is correct. You must
create the "app" folder in the root
directory of the SD card and put
the zip file in the "app" folder.
You are trying to install
the same application with
a different part number. Is
it OK to continue?
Displayed when you attempt
to update an application that
is the same but has a different
part number.
Check the file, and select [OK] or
[Cancel].
Some applications could
not be installed.
Displayed in the following
cases.
• You attempted to update
a module (application) in
use.
• The application is
corrupted.
Restart the control panel and repeat
the update procedure.
-
(The application you want
to update is not displayed
in the list of applications.)
• Make sure that the directory of the
SD card is correct. You must
create the "app" folder in the root
directory of the SD card and put
the zip file in the "app" folder.
• Check the application file in the
SD card.
Error Codes
Error codes may appear along with the message reporting the installation failure.
Installation of an application that cannot be used according to the system configuration was
attempted.
(Example: This occurs when installing an application with the copier, scanner and fax
functions on a non-MFP printer. However, if any of these functions can be used, the
application with such multiple functions can be installed.)
This occurs if the hard disk cannot be used.
An application that does not match the type (LP/MFP) or model has been installed. *
To Next Page
Loading...
